Labels:text | screenshot | diagram | black and white OCR: utes Options +7.5V [done] 15 10 5 0 5 10 1 Battery Electromyogram (EMG) Amplifier Battery Change: Input R10A 1. Unstow EMG batteries (two) from Speres Kit Connector Upper L2E/2 2. Unstow 6 x 150mm screwdriver Output Connector 3. Remove -7.5 volt battery plug (+ UP marking on housing) by rotating plug cow until clear of housing 0 4. Remove bottery, lobel, temp stow -7.5V 0 5. Install battery in + UP position (Battery polarity installed in + UP position; UP is Bettery outward or exterior pert of battery housing. flattened end of battery "+") Battery Plug, 6. Replace battery plug by rototing cw until Spring completely set in housing + 7. Remove + 7.5 volt battery (+ DN marking on EMG Amplifier housing) in same manner as step 3 Please replace the bed EMG's batteries per the above instructions Select "done" from Options when finished. MET GMT Figure 3. Output from the Diagnosis/Troubleshooting Module.
